Porsche 911 Carrera RS '74
![Album image #1 Album image #1](/albums/img/2/3/0/563230-30904-57-720.jpg)
![Album image #2 Album image #2](/albums/img/2/3/1/563231-30904-34-720.jpg)
![Album image #3 Album image #3](/albums/img/2/3/2/563232-30904-50-720.jpg)
![Album image #4 Album image #4](/albums/img/2/3/3/563233-30904-95-720.jpg)
![Album image #5 Album image #5](/albums/img/2/3/4/563234-30904-34-720.jpg)
![Album image #6 Album image #6](/albums/img/2/3/5/563235-30904-53-720.jpg)
![Album image #7 Album image #7](/albums/img/2/3/6/563236-30904-27-720.jpg)
![Album image #8 Album image #8](/albums/img/2/3/7/563237-30904-75-720.jpg)
![Album image #9 Album image #9](/albums/img/2/3/8/563238-30904-77-720.jpg)
![Album image #10 Album image #10](/albums/img/2/3/9/563239-30904-81-720.jpg)
![Album image #11 Album image #11](/albums/img/2/4/0/563240-30904-52-720.jpg)
![Album image #12 Album image #12](/albums/img/2/4/1/563241-30904-81-720.jpg)
Коментари
3 15 January 2019, 12:57
![](/profiles/img/50909-708-s.jpg)
Have this kit on the way to my house. I hope I can make it look half as good as yours. Any advice or warnings on it?
26 April 2019, 18:37
![](/profiles/img/42364-941-s.jpg)
Great job! I have a 911 on my stash shelf... hopefully I can pull off awesome like this!
26 April 2019, 18:51
![](/profiles/img/15819-423-s.jpg)
Very inspiring build. A great car to model - one with excellent maneuverability.
26 April 2019, 21:58
![](/profiles/img/30904-479-s.jpg)
Dear Allan Gage, sorry for delay...
There are some points of advice in this kit.
Rear suspension assembly is poor. It is necessary to sanding a lot to get fit it in the chassis.
The final assembly of the body with the rest of the kit is very difficult.
27 April 2019, 21:38
![](/profiles/img/50909-708-s.jpg)
Great my least favorite parts already...oh well i shall proceed with caution. Thanks for the response.
28 April 2019, 01:49
![](/profiles/img/73157-387-s.jpg)
Well done! What Color did you use dir the Green exactly? I was thinking about Tamiya TS 22 for my build...
26 June 2020, 19:49
![](/profiles/img/30904-479-s.jpg)
Hi Dennis. It was the color that I used. But it was decanted, because when I aplied directly from the can to the car, it boiled like a soda. So I aplied with a Aztek airbrush over Tamiya primer.
26 June 2020, 21:32
![](/profiles/img/73157-387-s.jpg)
Hi Alexandre. Thanks Mate! I Never had any Problems using Tamiya Spraypaint. I allways aply them directly from the spray can over a good coat of primer. Before using them i put the spray can in warm water for a few minutes. This way i get very smooth surfaces...
27 June 2020, 10:23
![](/profiles/img/12266-435-s.jpg)
Again, that green is awesome 👍 This kit is in the top 10 on my to do list
27 June 2020, 10:54
![](/profiles/img/30904-479-s.jpg)
Hi Dennis. Yes, I know the quality of Tamiya spray paints, but I used an old bottle, so I believe that it promotes the strange effect. I searched the internet and found that it is not uncommon. In the old spray can, the gas can incorporate into the paint, the same process of making a coke ... and the only way to solve it, is to decant the paint into a jar and shake it. Open the jar and let the gas escape. Repeat the process even to remove all gas. Do not this with a coke...
27 June 2020, 14:19
Album info
Porsche 911 Carrera RS '74 Fujimi 1/24, with full interior, trunk and motor (Enthusiast Model Series from Fujimi).