MAKING EXHAUST PIPES
These are the kit exhaust pipes. Really poor job from KP.
Take some .040" (1mm) styrene rod and drill a .025" (.6mm) hole in the end.
Put some flat black in the hole.
Paint the pipe steel colour or whatever you normally do.
The kit part would normally glue on here. Ugh!
Drill a hole to fit the pipe on an angle as shown.
Cut the rod to the correct length and glue it in.
Much better looking than the kit parts.
Коментари
3 June 2020, 14:37
Album info
Replace ugly kit parts with something more realistic.