1:144 Dragon A-6 Intruder
The painting of the cockpit and the primer are finished. Kit seats on the right, aftermarket on the left.
Environmental Control System ram air intake from sprue
GBU-10 from Revell F-15E kit
GBU-10 from Revell F-15E kit
First I glued the smaller bombs on the triple ejector racks. Then I put the central fuel tank in place, followed by the GBU-10s on the outer pilons. After that I glued the landing gear doors and finally the two complete racks with the 5-5 Mk 82s on the inner pilons.
Kommentarer
46 3 March, 15:49
Freak
You do know how to create anticipation, putting a detailed cockpit into a 1:144 A-6.
You do know how to create anticipation, putting a detailed cockpit into a 1:144 A-6.
4 March, 21:33
Mike Volkov
The cockpit is a product of RetroWings. 😊 The cut was a little bigger than it should have been. 😅 I use Tamiya Epoxy Putty, then when it has set, I paint it.
The cockpit is a product of RetroWings. 😊 The cut was a little bigger than it should have been. 😅 I use Tamiya Epoxy Putty, then when it has set, I paint it.
5 March, 08:16
Freak
Lovely progress pictures! I'm taking notes on how to layer a US Navy plane, this is a masterclass!
Lovely progress pictures! I'm taking notes on how to layer a US Navy plane, this is a masterclass!
2 April, 06:38