Revell 1/48 Eurofighter Typhoon 'Black Jack'
Kommentarer
21 29 January 2023, 15:06
Stefan Fraundorfer
I love this spectacular special painting. You did a perfect job.
I love this spectacular special painting. You did a perfect job.
29 January 2023, 15:31
Neil Page
looks as spectacular as the real thing! I'm guessing the 'Union Jacks' are decals ? How did they work?
looks as spectacular as the real thing! I'm guessing the 'Union Jacks' are decals ? How did they work?
29 January 2023, 18:02
Alistair
Thank you very much, everyone!
Yeah the Union Jacks are all decals, with the spine and tail painted red.
The Decals on the tops of the wing and on the tail aren't too bad, but the ones on the underside of the wing were difficult to get right.
They're very large so you have to cut them into smaller sections to get it all in the right place. And they're not quite the right size for the wing - they're not quite wide enough to reach the wingtips as they should, and they hang off the back a little so have to be trimmed down.
Thank you very much, everyone!
Yeah the Union Jacks are all decals, with the spine and tail painted red.
The Decals on the tops of the wing and on the tail aren't too bad, but the ones on the underside of the wing were difficult to get right.
They're very large so you have to cut them into smaller sections to get it all in the right place. And they're not quite the right size for the wing - they're not quite wide enough to reach the wingtips as they should, and they hang off the back a little so have to be trimmed down.
30 January 2023, 21:15
Selman Yarar
Yes that's exactly what happened to me half an hour ago.
Shame on you Revell.
I wonder what they were thinking about while designing.
Yes that's exactly what happened to me half an hour ago.
Shame on you Revell.
I wonder what they were thinking about while designing.
15 October 2023, 18:55
Joshua Corns
Amazing work mate. I had a couple of questions about the base dimensions and where to drill the hole for the rod. I'm a bit scared to make it completely out of balance and love the way it tilts up a tiny bit on your work.
Amazing work mate. I had a couple of questions about the base dimensions and where to drill the hole for the rod. I'm a bit scared to make it completely out of balance and love the way it tilts up a tiny bit on your work.
11 November 2023, 19:49