Custom spray booth
- Skala:
- 1:1
- Status:
- Idéer
- Satte igång:
- April 3, 2020
This is a huge booth that's capable of taking a full 1:25 semi trailer.
Projekt inventering
Scratchbuilt No kits or aftermaket sets are attached.
Fotoalbum
Kommentarer
3 April 2020, 20:37
Bozzer
Ok, this is the bare basics of the booth. It's 600 x 600mm square base (2' x 2') and slightly less in height. It's going to be extracted by two PC fans, through a chamber and out into the fresh air. To prevent any paint particles, clogging up the fans, and to prevent painting the surrounding neighborhood, a filter is going in, where the huge square is. At the top, will be perspex, clear. This is to allow light in, which will be a 600 x 600mm LED panel. Fingers crossed, it's all going to work!
Ok, this is the bare basics of the booth. It's 600 x 600mm square base (2' x 2') and slightly less in height. It's going to be extracted by two PC fans, through a chamber and out into the fresh air. To prevent any paint particles, clogging up the fans, and to prevent painting the surrounding neighborhood, a filter is going in, where the huge square is. At the top, will be perspex, clear. This is to allow light in, which will be a 600 x 600mm LED panel. Fingers crossed, it's all going to work!
3 April 2020, 20:50