Haber akışı

Martin Oostrom
I got the same kit somewhere, so following

Ben M
Same plus I owned a 63 in "real life"

Thomas O'Eh
This may be no consolation, but it is the same issue with the Revell Samba bus.

bughunter
Oh, that are a lot of ejection marks!
For raised ones I use a scalpel nr 15, if there is enough space around. In the middle of pic 1 are some with tight structures around. Here I would use a model chisel like this one (example, there are different sizes): Chisel F2 (Master Tools 09924, No)
Deepened ones can be closed with round pieces of styrene (made with punch and die, in the matching diameter.

Snake Plissken
The X-Acto #17 chisel blade is also excellent for removing ejector pin marks. It can be used in the normal chisel angle as well as perpendicular to the surface as a scraper. #17 Lightweight Chiseling Blades - 5 Pcs (X-ACTO X217, No)

Ben M
The metal floor should be corrugated on a type 2, so another approach would be to hide them under corrugated panels.

[img1]

Edouard Carr
Following 😉

Jennifer Nijhuis
Thank you so much for the comments. I'm in the middle of removing them. Some of them are really high. I use everything I have on the hand (Saw, chisel, scalpel, sandpaper). For some I even used a dremel (really cautious) Even if i would hide the behind corrugated panels (God idea by the way) I still have to remove them before.
You can see in the next picture how high there are. Ione was almost 1mm