Haber akışı
Daryl Fell
Thx for reporting this "DOUBLE". Please add the link of the other "double" in the field below.
15 November, 01:54
ineace
bu öğenin sahibi
bu öğenin sahibi
Bobby Allison
Chevrolet Monte Carlo 1982 Race Winner Salvinos JR Models 1:24
BAMC1982R (SALVINOS-01) 2020 Yeni parçalar 15 November, 01:53
Skyhiker
yeni bir fotoalbüm ekledi.
yeni bir fotoalbüm ekledi.
33 Görüntüler
Sukhoi Su-47 BerkutYeni: 14 November, 23:24 1:72
I made a lot of modifications on the stabilizers. They look much more like the original now.
proje: Sukhoi Su-47 Berkut
22 4 November, 17:12
Mr D
Coming along nicely 👍👍 More building 🤣 going ahead,
Smart and interesting aircraft, lm going to have to research n watch some YouTube videos on this aircraft.
Like the cockpit 👌
Coming along nicely 👍👍 More building 🤣 going ahead,
Smart and interesting aircraft, lm going to have to research n watch some YouTube videos on this aircraft.
Like the cockpit 👌
7 November, 22:39
Skyhiker
Yeah, it's kinda cool. Certainly it's different from the other Russian planes in looks.
Yeah, it's kinda cool. Certainly it's different from the other Russian planes in looks.
8 November, 17:18
Mr D
Better job on the nose shaping now, it was probably quite dependent on front aero due to wing position and design.
Could help with sonic boom too ??
Better job on the nose shaping now, it was probably quite dependent on front aero due to wing position and design.
Could help with sonic boom too ??
9 November, 11:28
Mr D
Ahh probably from airshow viewing ect they probably wanted to keep alot secret.
You will do it justice as usual I'm sure.
Thanks 👍👍
Ahh probably from airshow viewing ect they probably wanted to keep alot secret.
You will do it justice as usual I'm sure.
Thanks 👍👍
11 November, 17:52
Skyhiker
Yes, Zvezda put it out in the 90's sometime after the plane's first flight on September 1997. It's not a bad kit but a few adjustments are needed.
Yes, Zvezda put it out in the 90's sometime after the plane's first flight on September 1997. It's not a bad kit but a few adjustments are needed.
12 November, 18:17
Kace Wong
bu öğeyi istiyor
bu öğeyi istiyor
British Army
Challenger 1 Armoured Repair and Rescue Vehicle CRARRV Trumpeter 1:35
09613 2025* Yeni araç 15 November, 01:45
MadMan
bu öğeyi istiyor
bu öğeyi istiyor
Collectors' Hi-Grade Series
Volkswagen Type 2 Micro Bus (1963) 'Full Interior'Hasegawa 1:24
CH35 (CH35:4800) 1999 Yeni parçalar 15 November, 01:35
Nathan Dempsey
yeni bir fotoalbüm ekledi.
yeni bir fotoalbüm ekledi.
20 7 October, 01:51
Nathan Dempsey
The next project is up and running. This one will likely get a slow start as there's another hurricane headed my way…
The next project is up and running. This one will likely get a slow start as there's another hurricane headed my way…
7 October, 02:01
Nathan Dempsey
Well we survived that darn hurricane and had power restored yesterday by some fine Canadian fellows from Nova Scotia. The project continues with some progress to the fuselage.
Well we survived that darn hurricane and had power restored yesterday by some fine Canadian fellows from Nova Scotia. The project continues with some progress to the fuselage.
15 October, 00:45
Clifford Keesler
Watching. Glad you weathered the hurricane ok. Did not know you were in Florida. I am a transplanted Florida guy. I am from Panama City. Was down there the end of August, first time I had been back since 2001. Hurricane Michael sure messed up the place, but they have rebuilt a lot. The house I lived in from 1995-2001 no longer exist, hurricane Michael leveled it.
Watching. Glad you weathered the hurricane ok. Did not know you were in Florida. I am a transplanted Florida guy. I am from Panama City. Was down there the end of August, first time I had been back since 2001. Hurricane Michael sure messed up the place, but they have rebuilt a lot. The house I lived in from 1995-2001 no longer exist, hurricane Michael leveled it.
19 October, 00:07
Nathan Dempsey
We were part of mandatory evac. I sent the family away and stayed since my parents are next door in a 100 year old frame home. We were lucky and had minimal damage. We just lost large oaks and our entire cow field was a shallow lake. Power was out for a while but I'm used to living simple during such times. Yeah Michael was a monster.
The plastic in this kit is quite fragile. Getting parts off the tree cleanly is quite difficult. Very happy with the ResKit parts! They are very clean and easy to prepare.
We were part of mandatory evac. I sent the family away and stayed since my parents are next door in a 100 year old frame home. We were lucky and had minimal damage. We just lost large oaks and our entire cow field was a shallow lake. Power was out for a while but I'm used to living simple during such times. Yeah Michael was a monster.
The plastic in this kit is quite fragile. Getting parts off the tree cleanly is quite difficult. Very happy with the ResKit parts! They are very clean and easy to prepare.
19 October, 20:11
Nathan Dempsey
More work today included adding etched parts to the rear fuselage and filling large holes intended for oversized antennas. Will be replacing all antennas with etched parts or thin plastic sheet.
More work today included adding etched parts to the rear fuselage and filling large holes intended for oversized antennas. Will be replacing all antennas with etched parts or thin plastic sheet.
23 October, 18:21
Clifford Keesler
Looking good Nathan. Glad you only had minor damage, and all is well.
Looking good Nathan. Glad you only had minor damage, and all is well.
23 October, 23:15
Clifford Keesler
I have 2 ESCI Mirage 2000's wonder if they are the same as the Heller kit?
I have 2 ESCI Mirage 2000's wonder if they are the same as the Heller kit?
23 October, 23:16
Nathan Dempsey
Thank you sir! The Heller kit is the same as the Eduard kit. I believe the ESCI kit is now the Italeri kit.
Thank you sir! The Heller kit is the same as the Eduard kit. I believe the ESCI kit is now the Italeri kit.
24 October, 00:10
Nathan Dempsey
Work continues. Today I added some etched hydraulic lines to the rear landing gear. Preparation begins for the ResKit wheel set.
Work continues. Today I added some etched hydraulic lines to the rear landing gear. Preparation begins for the ResKit wheel set.
30 October, 03:14
Dutch
Nathan, I love checking in from time to time, (super busy with Hurricane Helene and Milton recovery at the house and the rented house.). Anyway, glad to see you start this project. Did you ever build the Monogram Mirage 2000 and ESCI Jaguar I sold you? K/r, Dutch
Nathan, I love checking in from time to time, (super busy with Hurricane Helene and Milton recovery at the house and the rented house.). Anyway, glad to see you start this project. Did you ever build the Monogram Mirage 2000 and ESCI Jaguar I sold you? K/r, Dutch
31 October, 13:33
Nathan Dempsey
Thanks Clifford & Desert!
Dutch: Same here. Still cutting downed trees and burning it all. Too much to place by the streets. The Mirage waits in the stash and the Jag was built as a close copy of my Kosovo build and given to a friend.
Thanks Clifford & Desert!
Dutch: Same here. Still cutting downed trees and burning it all. Too much to place by the streets. The Mirage waits in the stash and the Jag was built as a close copy of my Kosovo build and given to a friend.
31 October, 14:47
Nathan Dempsey
Added some photos of continuing work which includes more paint work on the landing gear and exhaust, the addition of the painted ejection seat to the cockpit & the completed external fuel tank.
Added some photos of continuing work which includes more paint work on the landing gear and exhaust, the addition of the painted ejection seat to the cockpit & the completed external fuel tank.
3 November, 21:06
Desert Marlin
Looks great! I suppose you are aware that the Mirage 2000 series aircraft have the option of an arresting hook or a parachute for landing? I believe either can be installed but only one of the two depending on airfields and conditions. Referring to photo #5.
Looks great! I suppose you are aware that the Mirage 2000 series aircraft have the option of an arresting hook or a parachute for landing? I believe either can be installed but only one of the two depending on airfields and conditions. Referring to photo #5.
4 November, 03:47
Nathan Dempsey
Thanks Clifford & thanks for the catch on that parachute housing Desert!
I found a good picture of a '91 Mirage 2000 with the bigger chaff dispenser replacing the back of that housing. I'll need to go back and file that off and change the position of all the chaff dispensers. I'll add some pictures this evening.
Thanks Clifford & thanks for the catch on that parachute housing Desert!
I found a good picture of a '91 Mirage 2000 with the bigger chaff dispenser replacing the back of that housing. I'll need to go back and file that off and change the position of all the chaff dispensers. I'll add some pictures this evening.
7 November, 16:51
Laurent VILLANUEVA HELLER ForEver
color pit = humbrol 27
radome = 64 ,
grey 127
blue = 144 with white...
color pit = humbrol 27
radome = 64 ,
grey 127
blue = 144 with white...
7 November, 17:03
Nathan Dempsey
Welcome Laurent and thanks for the color info! Paint work is near.
Thanks Guy! 🙂
Welcome Laurent and thanks for the color info! Paint work is near.
Thanks Guy! 🙂
8 November, 02:39
Desert Marlin
The chaff dispenser sits over the parachute housing and therefore the chute can still be used!
The chaff dispenser sits over the parachute housing and therefore the chute can still be used!
8 November, 03:36
Nathan Dempsey
Desert: Glad you pointed it out. I'd have been crying if I'd already started paint work.
Clifford: Thank you Sir!
Finally back at the bench and was able to do some pre-shading today.
Desert: Glad you pointed it out. I'd have been crying if I'd already started paint work.
Clifford: Thank you Sir!
Finally back at the bench and was able to do some pre-shading today.
14 November, 21:05
Clifford Keesler
Looking most impressive Nathan, another master piece in the making.
Looking most impressive Nathan, another master piece in the making.
15 November, 01:33
/tr/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=tr
35
35
/tr/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo