WIP F-16C "Wraith"-Aggressor / 64th AGRS
The Office: Red Fox F-16-Cockpit
Reinforcement plates from 0.25mm styrene cut out with the Cricut Cutter
Ejection Seat Cover made from tissue, water and PVA
HUD Cover made from tissue, water and PVA
Primed with Mr. Surface 1500 black
Tamiya XF-85 Rubber Black. I later applied another final thin coat of it.
IR-missile warning sensors are black again (white tip will follow), gun nozzle and aerial refueling receptacle painted grey
Masking the wheel bays for repainting
Done!
Every Block 42 Viper has this air scoop. Guess what!? Not this one. I won't remove it now.
The instructions for the Wraith-Decals are a bit tricky to read. Compare the two sides of the jet. Decals are bigger/smaller or in different locations. Check your references!!!
And unfortunately the print of the decals isn't good either. Look at the diplacement.
But from a functional view, the decals are superb. Great to work with and looking good.
All Decals done!
Yorumlar
21 14 October 2023, 09:29
Maciej Bellos
Grabbing one next to Jos.
If possible, thin down the reenforcement plates. I had the same issue with the side radar panels on my Su-57. They came out too prominent.
Grabbing one next to Jos.
If possible, thin down the reenforcement plates. I had the same issue with the side radar panels on my Su-57. They came out too prominent.
14 October 2023, 15:08
CaptGPF
Great result - too bad a lot of the underlying pre-shade doesn't show through the photos!
Great result - too bad a lot of the underlying pre-shade doesn't show through the photos!
29 February, 15:54