ölçekli modelleme veritabanı | depo yöneticisi
Flip
Phil Marchese (Flip)
US

Curtiss XF14C-2 (PK103 conv)

Yorumlar

18 November 2013, 13:48
Alain Courouge
Nice build. But what's this ??
18 November 2013, 13:54
Phil Marchese
The Curtiss XF14C-2 for USN. Followed by the boom-tailed XFR15C in two tail configurations. Post-war, failed to go beyond the XP-87 All weather interceptor, ending the era of an airplane designer.
18 November 2013, 16:16
Phil Marchese
XF15C ( R is a typo)
18 November 2013, 16:17

Album info

1:72 scale Matchbox Beaufighter conversion. Air Defense procedures required the identification of prototypes. Indentification Yellow for this purpose was in use as examplified by several contractors. North American Aviation, Northrop, Grumman, and Republic prototypes all exhibit the yellow marking. These were often limited to cowls or spinners after the advent of natural metal finishes.

Note the swan diving beauty has both arms out and appears head forward in mirror images on each side of cowl. The 35" wing insignia is between the airelon cutout (as prescribed) and the mainspar ( behind gearbay ). The smaller fuselage star is 30" type 3.

Handholds lead from wing fairing to cockpit. The wing itself is set off by a no step red stripe. The rear vision panels are basically flat and lightly supported. The whole rear section meets the upper deck in a reverse curve. The center section is framed however it has a blown hood.

The wheel wells extend inward and the gear doors and wheel doors are separately l

10 Görüntüler
1:72
Tamamlanan
1:72 Beaufighter Mk.X (Matchbox PK-103)

Tüm albümler

Tüm albümleri görüntüle »