ölçekli modelleme veritabanı | depo yöneticisi
racingkarsshop
Kars Jans (racingkarsshop)
NL

2013 Ferrari F138 China

Yorumlar

21 November 2014, 15:46
Steve Wilson
...
Top job Kars... Mmmmmmm!!! Ferrari😛
21 November 2014, 15:50
Kars Jans
Your and my favourite.
21 November 2014, 15:51
Rodrigo Godinho
Hi Kars. Just bought this model today. great work by the way. can you give me insight on how you do the wear on the tires? they look very cool as it would finish the race. thanks
23 September 2017, 21:19
Kars Jans
Hi Rodrigo, yes sure. I use sanding paper. I have a proxxon drill with a sanding tool. I will add a picture to this album to clarify. You could also visit my website and have a look at my WIP's. www.racingkars.nl
24 September 2017, 07:21
Rodrigo Godinho
Thanks Kars. I also use sanding paper but only with my hand.. The proxxon give it another cool look. need to invest 🙂 thanks again. keep up the good work
25 September 2017, 08:19
Kars Jans
It's the speed of the tool that somewhat melts the rubber a bit. This gives the tire grain look. A dremel would also work, or even other machines.
25 September 2017, 16:48

Album info

My 2013 Ferrari F138 China as driven by Felippe Massa is ready. It's a 1/20 scale Fujimi kit. Because of known problems i did not entirely follow the plans. The engine cover did not fit well. I had to make some changes to the rear wheel suspension to make it 'fit'.

20 Görüntüler
1:20
Tamamlanan
1:20 Ferrari F138 (Fujimi 09176)1:20 Ferrari F138 Full Set Massa (no. 4) (Acu-Stion ATS-9778)1:20 Ferrari F138 (Studio27 ST27-CD20017)

Tüm albümler

Tüm albümleri görüntüle »