'93 Corvette LT-1
![Album image #1 Album image #1](/albums/img/7/8/2/153782-15819-18-720.jpg)
![Album image #2 Album image #2](/albums/img/7/8/3/153783-15819-47-720.jpg)
![Album image #3 Album image #3](/albums/img/7/8/4/153784-15819-61-720.jpg)
![Album image #4 Album image #4](/albums/img/7/8/6/153786-15819-67-720.jpg)
![Album image #5 Album image #5](/albums/img/7/8/7/153787-15819-52-720.jpg)
![Album image #6 Album image #6](/albums/img/2/4/6/154246-15819-81-720.jpg)
![Album image #7 Album image #7](/albums/img/8/6/3/158863-15819-71-720.jpg)
![Album image #8 Album image #8](/albums/img/8/6/4/158864-15819-12-720.jpg)
Yorumlar
27 December 2014, 22:24
![](/profiles/img/15819-423-s.jpg)
The Collector and Replica Builders Club of Dayton, OH is thinking about having a swap meet where you bring your unfinished model and swap for another that you would then finish. This was one of several kits started and not finished that I inherited and as you might notice the elephant in the room is the hood is missing. But like all kit building it is a learning experience and it was fun! I have this model inside my Joe's garage getting serviced! I just bought an oil spill yesterday for $8.75 on ebay to put under the car. Poor baby!
20 January 2015, 15:06
Album info
The 1993 Corvette LT-1 had the new LT-1 350 cubic inch V-8 small block (included revised cylinder heads, reverse flow cool, and optical distributor built into the front cover and a computer controlled electronic fuel injection system), a six-speed transmission, single leaf spring independent rear suspension and a traction control devices that works the ABS brake control system and the engine control computer.