Scratchbuild of Soviet 76,2mm AA Gun mod.1931(3-K)
Day 29
Day 29
Gunsight mechanism (day 25)
Test fitting of gunsight
Progress for 22 days
Progress for 22 days
Progress for 10 days
The Gun(MMH-Sofia)
The Gun 2(Finland)
Gun Data(Museum of Military History-Sofia)
Starting points-drawings
Some sub-assemblies
Elevation,balance and seat for the gunner added
Yorumlar
1 29 November 2016, 15:55
Bart Goesaertman, that looks nice so far... following with interest... how did you close the brass cone? soldering, and how did you bring the form over on the brass?
29 November 2016, 16:10
Angel YovtshevThanks for your comments guys!It has been both challenging and quite funny build sofar.
To your question Bart: I cut circle of Plastruct sheet wider than the upper hole of the cone, glued a centerline tube in it, gave it a good CA coating and rammed it from the bottom of the cone up, till it got stuck in the walls.Then I added some scrap styrene on top of the circle and glued the final one-you won't see it in these pictures- that is wider than the upper hole of the cone.
Same happened to the bottom of the cone.
30 November 2016, 13:40
Angel YovtshevThanks for your comments, mates!@ Rui- yes,mate I do work with a microscope-it consists of a pair of brown (short-sighted) eyes😉
5 January 2017, 09:47
Bart GoesaertI use the same one, albeit a grey green color option 😉...
Nice work on this one...
5 January 2017, 09:55
