Astrakhan Buyan Class Corvette Project 21630
1January 28, 2020
2January 28, 2020
3January 28, 2020
4January 28, 2020
5January 29, 2020
6January 29, 2020
7January 30, 2020
8January 30, 2020Glued both halves... I knew there was a difference in length, but in width to... more then 1 mm gap between certain parts of lower and upper hull...
9January 30, 2020more then 1mm in length too... stern looks different then
10January 30, 2020real situation
11January 30, 2020real situation
12January 30, 2020
13January 31, 2020Bitten the bullet
14January 31, 2020dryfit
15January 31, 2020and glued... so it takes 24h to dry.. then putty time...
16January 31, 2020ready for checking with paint
17January 31, 2020ready for checking with paint
18January 31, 2020ready for checking with paint
19January 31, 2020ready for checking with paint
20February 6, 2020last check
21February 6, 2020last check
22February 7, 2020after carving slots where the glue kept protruding and filling them, seems it gave the result I was after
23February 7, 2020after carving slots where the glue kept protruding and filling them, seems it gave the result I was after
24February 11, 2020something off... main part should consist of 2 parts, molded as one, PE-part doesn't fit over it
25February 11, 2020to avoid as much attachments points, I cut my PE at an angle, as close as possible to the part
26February 11, 2020then I put it between some toothless pliers
27February 11, 2020sand it flush all around
28February 11, 2020then some careful cutting, and voila, first weapon ready
29February 14, 2020a lot of small parts to add
30February 14, 2020doors and details added
31February 14, 2020antenna busy to be built up
32February 14, 2020antenna busy to be built up
33February 14, 2020general overview
34February 14, 2020inlet for the turbines, guards still to be added
Yorumlar
16 October 2024, 23:50 -
