ölçekli modelleme veritabanı | depo yöneticisi
Yoda80
David Culp (Yoda80)
US

Pave Nail

Yorumlar

9 31 August 2022, 01:56
David Culp
Pylon and laser designator are 3D printed.
1 September 2022, 19:33
David Culp
NOTE:
1. The kit is missing the fifth step (bottom/aft).
2. The kit is missing the middle fuel tank cap (on top of wing).
3. Props should be in flat pitch.
4. Kit nose tire is wrong - use aftermarket replacement.
5. Inlet covers are 3D printed, although this is now available on the aftermarket in resin.
6. Oil cooler doors are open whenever the landing gear is down.
1 September 2022, 19:38

Project info

3 Görüntüler
1:32
Tamamlanan
1:32 OV-10A/C "Bronco" (Kitty Hawk KH32004)1:32 "You're Cleared in Hot!" (AOA decals 32-006)1:32 OV-10 Bronco Wheel Set (KTH kit) (AMS Resin 32111)2+

Tüm albümler

Tüm albümleri görüntüle »