Pave Nail

1
August 31, 2022
2
August 31, 2022
This shot shows the laser pod and pylon under the cockpit. Note that the KittyHawk kit omits the bottom-rear step, so this must be added. Also the front step should be inline with the other steps - KH made the step a bit too high.
3
August 31, 2022
To build with the cargo door open you must add detail to the cargo bay. I added floor detail, sidewalls, hydraulic pump, wiring, oxygen bottles, radio rack. Cargo door first has all details sanded down, then the gust lock and canvas bag were added.

Yorumlar

9 31 August 2022, 01:56

David Culp
Pylon and laser designator are 3D printed.

1 September 2022, 19:33

David Culp
NOTE:
1. The kit is missing the fifth step (bottom/aft).
2. The kit is missing the middle fuel tank cap (on top of wing).
3. Props should be in flat pitch.
4. Kit nose tire is wrong - use aftermarket replacement.
5. Inlet covers are 3D printed, although this is now available on the aftermarket in resin.
6. Oil cooler doors are open whenever the landing gear is down.

1 September 2022, 19:38

Project info

KH OV-10A Pave Nail

3 Görüntüler

1:32

Tamamlanan

1:32 OV-10A/C "Bronco" (Kitty Hawk KH32004)

1:32 "You're Cleared in Hot!" (AOA decals 32-006)

1:32 OV-10 Bronco Wheel Set (KTH kit) (AMS Resin 32111)

Tüm albümler

Tüm albümleri görüntüle »