Nissan R390 GT1 LM 1998 [Job Log]

Jv
This will be interesting

bughunter
Is that resin dust on your bench (pic21)? I only grind this under water, it acts like asbestos in your lungs.
en.wikipedia.org/wiki/Pneumoconiosis

MS K
Thanks guys.
@bughunter I worked with a mask on, but as you said, I think I need to be more careful.

Kyle DeHart
Lovely stuff MS

Julian Herrero aka Yuri
Following

Jv
Lots of challenges MS K
Good to hear you are looking after your self

KlausH
Fantastic job! I own this conversion kit, but when I see your work... I'm not sure if i will find this patience. Anyway, it's a pleasure to watch your build! 👍

MS K
Thanks guys 🙂
@KlausH : If you can match the glass parts well, using a resin body might not be a bad choice.
And if the decal state is healthy, it is not expected that the stress will be this severe.

KlausH
Thank you! 🙂

Jv
Though this was going to be a big challenge
And then decals turned out to be very problematic
I don't think I have seen this level of challenge before
Amazing you made a good looking model of it
Sure I would not have been abel to do that Hats of for you

HuetMotors
Nice realisation, hard and perfect job !

MS K
Thanks Jv, HuetMotors 🙂