Стрічка новин
Marc Verlot
володіє цим предметом
володіє цим предметом
Les pertes de la chasse allemande de jour en Belgique 1940-1945 Tome 1: Les Bf 109 et FW 190 engages dans le ciel belge (194...
La Belgique en guerre № 3
Pierre Watteeuw
1999 6 August, 21:20
blackflag
хоче цей предмет
хоче цей предмет
German
Machineguns Set (MG-34, MG-42, ZB-53 & equipment) MiniArt 1:35
35250 2017 Нова прес-форма Багато тем (3)6 August, 21:17
Seb Talaga
володіє цим предметом
володіє цим предметом
Panzer III (North Africa) Sand Armor
Panzer Art 1:35
RE35-140 6 August, 21:09
Seb Talaga
володіє цим предметом
володіє цим предметом
Towing cable 2x for PzKpfw-III Ausf. G-L Tanks
Eureka XXL 1:35
ER-3517 6 August, 21:09
Jam Fjord
хоче цей предмет
хоче цей предмет
'The English Patient' Movie aircraft Tiger Moth and Stearman
ICM 1:32
32053 2022 Змінено ??? Багато тем (2)6 August, 21:06
Seb Talaga
володіє цим предметом
володіє цим предметом
Panzer III Ausf. J / AB41 - Polish Carpathian Lancer
Echelon Fine Details 1:35
D356046 2008 Нова прес-форма Багато тем (2)6 August, 21:05
Seb Talaga
володіє цим предметом
володіє цим предметом
Lifting Hooks-B For Panzer III Panzer IV
Heavy Hobby 1:35
HH-35001 2021 Нова прес-форма Багато тем (2)6 August, 21:05
Stephan Fässler
додав новий фотоальбом.
додав новий фотоальбом.
21 21 June, 18:01
Nicolas
Oh, a kit from my favorite area of interest. I'm in. Great start with the instrument panel.
Oh, a kit from my favorite area of interest. I'm in. Great start with the instrument panel.
10 July, 05:35
Michael Kohl
Like the plane and the livery you are going for.
My two cents on one or two aspects: I found the brass undercarrige and the cockpit section you listed as aftermarket pretty useless. The undercarriage doesn´t solve the problem to ease the alignment of the landing gear and the cockpit section doesn´t provide any better detail than the kit parts. I set both aside and rescribed the soft outlines of the cockpit doors. Pouring transparent resin into the cabin windows gave a nice flush appearance. You may consider that.
Good luck with your build. I will follow with keen interest.
Like the plane and the livery you are going for.
My two cents on one or two aspects: I found the brass undercarrige and the cockpit section you listed as aftermarket pretty useless. The undercarriage doesn´t solve the problem to ease the alignment of the landing gear and the cockpit section doesn´t provide any better detail than the kit parts. I set both aside and rescribed the soft outlines of the cockpit doors. Pouring transparent resin into the cabin windows gave a nice flush appearance. You may consider that.
Good luck with your build. I will follow with keen interest.
10 July, 07:54
Stephan Fässler
Thanks Michael and Nicolas. As my second kit to build, I thought I spice it up a bit with some aftermarket stuff, indeed, the new cabin with the new windows gave me some head scratching as to how install it, then figured it eventually out. My alignment looks a bit messy and I hope u can make it look aligned with putty etc… so far my opinion as an inexperienced builder is that you could safely leave it stock, as is….
I did not come yet to the brass parts and hope it will be better with these parts. Let's see 🙂
Thanks Michael and Nicolas. As my second kit to build, I thought I spice it up a bit with some aftermarket stuff, indeed, the new cabin with the new windows gave me some head scratching as to how install it, then figured it eventually out. My alignment looks a bit messy and I hope u can make it look aligned with putty etc… so far my opinion as an inexperienced builder is that you could safely leave it stock, as is….
I did not come yet to the brass parts and hope it will be better with these parts. Let's see 🙂
10 July, 08:07
Thomas Kolb
I am happy to take a seat! I personally find red liveries extremely difficult to pull off, so I am watching with great interest!
I am happy to take a seat! I personally find red liveries extremely difficult to pull off, so I am watching with great interest!
10 July, 08:54
Łukasz Gliński
Following this challenge.
The Aerocraft cockpit will require a lot of sanding, but the original windshield is definitely too narrow - been there, done that 🙂
Following this challenge.
The Aerocraft cockpit will require a lot of sanding, but the original windshield is definitely too narrow - been there, done that 🙂
10 July, 11:15
Zbynek Honzik
Taking a seat. And fingers crossed that the strength and motivation will last until successful completion!
Taking a seat. And fingers crossed that the strength and motivation will last until successful completion!
16 July, 19:31
Stephan Fässler
Calling it complete for now.
Overall I enjoyed this kit, tricky to paint the red stripes and the nose was not properly done.
As a beginner I probably would not recommend the cockpit mod unless you have the proper tools, which I was missing sometimes 🙂
This was brush painted and spray can paint from revell I purchased with the kit to get started, meanwhile upgraded my collection with Mr Hobby and MRP. Revell is just awful for airbrush and mediocre for brush painting, but then again, I am no expert.
Unfortunately the „twotter" has some slight tilt, one of many mistakes happened during the build, but I'm happy I did not have to bin the whole thing 🙂
Cheers and onwards to the next one. You may deboard now…
Calling it complete for now.
Overall I enjoyed this kit, tricky to paint the red stripes and the nose was not properly done.
As a beginner I probably would not recommend the cockpit mod unless you have the proper tools, which I was missing sometimes 🙂
This was brush painted and spray can paint from revell I purchased with the kit to get started, meanwhile upgraded my collection with Mr Hobby and MRP. Revell is just awful for airbrush and mediocre for brush painting, but then again, I am no expert.
Unfortunately the „twotter" has some slight tilt, one of many mistakes happened during the build, but I'm happy I did not have to bin the whole thing 🙂
Cheers and onwards to the next one. You may deboard now…
6 August, 17:23
Martin Oostrom
Making mistakes and learning from them is a big part of this hobby. It helps that there are a lot of folk here, who already did the mistake part, so you can do the learning. You're well underway in that department.
Well done for a 2nd kit Stephan.
Making mistakes and learning from them is a big part of this hobby. It helps that there are a lot of folk here, who already did the mistake part, so you can do the learning. You're well underway in that department.
Well done for a 2nd kit Stephan.
6 August, 20:01
Łukasz Gliński
Exactly, good job for a 2nd kit and agree with your conclusions - bin the Revell paints 🙂
Exactly, good job for a 2nd kit and agree with your conclusions - bin the Revell paints 🙂
6 August, 21:02
/uk/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=uk
35
35
/uk/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo