1/35 Tamiya Tiger I Ausf. E - Wittmann Villers Bocage
Коментарі
55 28 March, 16:26
coporadoBuild completed so far. Still waiting for the metal barrel. Quite challenging to attach the Zimmerit- PE parts. Was annoying when it comes to round shapes on the turret front armor. Treating those metal parts with some heat, made them much more handy to shape. First time using Friul tracks, very time consuming, but the best track result I´ve seen so far 🙂
1 April, 13:59
coporadoLower part of the tank was painted and received weathering. Tracks were mounted and connected. Rear fenders were the installed. Next is masking lower section and painting the upper parts.
2 June, 10:18
Christoph KunzNice job. I'm taking a seat.
Is it going to be some "Magdeburg-stuff" again?
2 June, 11:03
coporadoThe tank received several rounds of paint. Starting with red brown primer, followed by dark yellow as base color and finally the camo pattern. Next is detail painting, and weathering.
9 June, 15:30
coporadoInitial weathering steps were conducted; chipping the Zimmerit and the metal surfaces.
16 June, 09:20
coporadoThanks, Nick!
The exhaust was painted in a medium grey first. The parts having armor plates underneath were left in the original painting, as these area is less affected by heat and corrosion. Then a warm white followed by a reddish brown was applied using the sponge technique. Next was rust tones painted and blended with enamels. Colors of the original camo scheme where then applied with a sponge in the areas with less corrosion, to turn out the different stages of heat impact. Finally the upper parts received a slightly black shade to simulate the exhaust fume grime.
23 June, 08:21
coporadoKick off for the base. Styrofoam is the desired material for house, road and pavement. As the road and pavement is covered with lots of dirt and debris, I added cobblestone only randomly. For the road thin sheets of styrofoam were shaped using a 3D printed rolling pin. In order to create more texture the stones were carved with a pencil. For the pavement an old brush was used to shape the small stones. Everything was painted in several greyish, brownish, sandy tones with acrylics.
The shape of house was cut with the Proxxon hot wire. To make the facade more interesting I added some "decoration" around the upper windows. A border seperates the upper and lower floor. Next is closing the gaps between the decoration elements at the upper windows and cover the lower floor with wood.
28 July, 07:18
coporadoSlowly taking shape. Lower floor fassade updated with some wooden panels. Dirt and debris was added to the road and pavement and painted with the airbrush. I used the same colors I used for weathering the tank tracks. Next is windows and door installation and of course detailing the interior.
18 August, 12:32
coporadoLower and upper floor and walls were detailed using Balsa wood and wallpaper. Added windows using Balsa and lasercut as well as some transparent plastic for the glas parts. Also the infantry miniatures arrived meanwhile.
31 August, 13:17
coporadoScratch built some interior from balsa wood and plastic residues. The attic floor was installed. Next is finally building the lower floor entrance and preparing the roof.
9 September, 12:26
coporadoAs an important detail, I added the sign with the shop name where the Tiger was abandoned in Villers Bocage in 1944. Also the advertising was printed in a suitable font and prepared for installation.
13 October, 15:09
coporadoSlowly getting there. The roof was installed, using Juweela roof tiles. Final details added and glued to the interior. Next is painting the two fellows passing by.
30 October, 10:50
