WIP

Lots of flash and milky looking clear parts. Let’s see how this one will go. 

I spent a few bucks on canopy masks, will let you know how they fit. Talking about the canopy, I can confirm that the fit is not great and will require a lot of extra effort.
I applied the first paint on the cockpit floor, the seats and the rotor blades. I used XF-53 (Tamiya neutral grey) instead of the suggested Revell dark grey 378. It looks somewhat lighter, but at least for the rotor blades it is a close enough match with the reference photos I found online. 

Interior mostly finished. Watch out, the drilling scheme is off for this version. If anyone has a suggestion how to squeeze 10g below the dashboard, I am looking forward to your input. For reference, I put 10g of lead from the fishing shop. 

I performed some surgery on the main rotor blades. Orientation should be fine now, still some clean up to be done. Thanks for the hint! 

Some detail added around the fenestron, made from Evergreen styrene and stretched sprue. 

Small parts replaced using wire and stretched sprue 

Filling that gap using styrene strips and putty. 

Surgery and subsequent cleanup mostly successful. Rotor blades are now in correct orientation.