F-100D Super Sabre

1
April 16, 2013
Modified seat with added PE bits
2
April 16, 2013
Exhaust from Eduard
3
April 16, 2013
parts of cockpit ready for assembly
4
April 16, 2013
cockpit in place
5
April 16, 2013
fuselage halves ready for assembly
6
April 25, 2013
I have closed holes for pylons I won't need
7
April 25, 2013
first look shows minor need for filling
8
April 25, 2013
begins to take shape 🙂
9
April 25, 2013
needed 3 steps to fill and set bad upper left wing-to-fuselage joint
10
April 25, 2013
added some wiring in wheel bays
11
April 25, 2013
I have managed to drop the plane and break paper-thin nose. This was corrected with piece of styrene sheet, filled with super-glue
12
May 2, 2013
Paint session lasted for few days - darker panels were masked with low-tack Tamiya tape
13
May 2, 2013
after unmasking
14
May 2, 2013
almost there...
15
May 2, 2013
close-up of engine area, of darker shade
16
May 2, 2013
17
May 2, 2013
18
May 8, 2013
decals are on, with some nuisance...
19
May 8, 2013
... but look nice 🙂
20
May 9, 2013
I didn't like look of joint between windshield and fuselage...
21
May 9, 2013
so I made another "panel" out of thin aluminium sheet
22
May 9, 2013
Interior is finished, finally...
23
May 9, 2013
few more details and tiny bits...
24
May 9, 2013
and finally it's finished!!!
25
May 11, 2013
finished model
26
May 11, 2013
finished model
27
May 11, 2013
finished model
28
May 11, 2013
finished model
29
May 11, 2013
30
May 11, 2013
31
May 11, 2013
32
May 11, 2013
33
May 11, 2013
34
May 11, 2013
35
May 11, 2013
36
May 11, 2013

Коментарі

1 16 April 2013, 09:06

Zoran Jakovljevic
Guido, you should think of including Eduard's set and vacformed canopy - it really improves the model 🙂 BTW, this is the same Esci/Italeri tool, only in Revell's box.

16 April 2013, 10:31

Luc B
great start, I'm tuned in

16 April 2013, 15:56

Gordon Sørensen
Fantastic work on the cockpit!

16 April 2013, 16:17

Burkhard D
Nooo, this is not 1:72, or is it? 😉 👍👍👍

16 April 2013, 18:00

Zoran Jakovljevic
Thanks everybody, I really appreciate that 🙂
Guido, I don't know about Aires, but it looks much better, especially in the rear part of the cockpit. I'm quite satisfied with this solution, but it requires some additional scratchbuilding :-/

16 April 2013, 22:59

Zoran Jakovljevic
Added photos of the finished model 🙂

11 May 2013, 05:12

Sebastijan Videc
wonderful looking Hun!

11 May 2013, 05:33

Zoran Jakovljevic
Thanks, Seb and Guido 🙂
Guido, Eduard gives small etched rectangle (4x2mm) that attaches to the inside of canopy's top rear part and goes into slot in fuselage. You'll also notice few cubes - I used one as a support for the canopy frame until the superglue dries.

11 May 2013, 16:05

Frank Krause
Very nice result, Zoran! 👍 I especially like the cockpit and the metal effect of the plane.

11 May 2013, 16:13

Bill Gilman
Very colourful markings, it looks great! Even after all these years, the old Esci kit is still the best F-100 out there.

11 May 2013, 16:55

Luc B
great!!!!

12 May 2013, 21:05

Project info

North American F-100D Super Sabre

36 зображення

1:72

Завершені

Усі альбоми

Переглянути всі альбоми »