SU-30MKI SB107 Indian Air Force
Коментарі
11 April 2019, 01:27
Michael Phillips
Nice! I will be following along, I just recently built an MKM using the same conversion kit. You can see the albums here:
#034 Hobby Boss Su-30MKM Flanker-H "Keeper of KL" | Project by Fighting 84 (1:48)
If you have any questions about the conversion let me know, even though you are doing an MKI which has quite a few differences.
Nice! I will be following along, I just recently built an MKM using the same conversion kit. You can see the albums here:
#034 Hobby Boss Su-30MKM Flanker-H "Keeper of KL" | Project by Fighting 84 (1:48)
If you have any questions about the conversion let me know, even though you are doing an MKI which has quite a few differences.
11 April 2019, 03:33
PK99
Hello Sir,
I have seen your build on ARC, and followed your guidance and used a rotary tool the cut the plastic. Still need some sanding and clean up.
Hello Sir,
I have seen your build on ARC, and followed your guidance and used a rotary tool the cut the plastic. Still need some sanding and clean up.
11 April 2019, 13:21
Michael Phillips
Ahhhh, so that was you on my ARC WIP thread. Very cool. I am looking forward to watching your progress.
Ahhhh, so that was you on my ARC WIP thread. Very cool. I am looking forward to watching your progress.
11 April 2019, 14:53
Nathan Dempsey
Hi PKMIG21FL and Michael. May I ask where either of you purchased your conversion for this kit?
Hi PKMIG21FL and Michael. May I ask where either of you purchased your conversion for this kit?
11 April 2019, 16:28
PK99
Hi Sir,
facebook.com/nmascalemodelszone/
This is the page of Naza Model Art on FB. He accepts paypal and ships worldwide.
Hi Sir,
facebook.com/nmascalemodelszone/
This is the page of Naza Model Art on FB. He accepts paypal and ships worldwide.
11 April 2019, 17:10
Michael Phillips
Yep, as above. Having completed this conversion, I must say the resin parts fit very well if you cut along the correct lines on the kit. I was very impressed. The negatives I have are the panel lines in the resin shoulders are quite deep and do stand out a little compared to the rest of the HB plastic. One of my vertical tails had a very slight bend on the very top fin cap portion, and there was a small chip in the fin cap trailing edge of the other. The tail detail is very delicate there. Handle the tails in particular with extreme care.
Yep, as above. Having completed this conversion, I must say the resin parts fit very well if you cut along the correct lines on the kit. I was very impressed. The negatives I have are the panel lines in the resin shoulders are quite deep and do stand out a little compared to the rest of the HB plastic. One of my vertical tails had a very slight bend on the very top fin cap portion, and there was a small chip in the fin cap trailing edge of the other. The tail detail is very delicate there. Handle the tails in particular with extreme care.
11 April 2019, 17:50
Album info
Dremel used to cut off parts.