SMK Project
Коментарі
16 21 January 2021, 20:07
![](/profiles/img/88855-657-s.jpg)
Yes I did. But I'm not sure if that was originally on vehicle (I think yes). Only couple photos are available and couple fuzzy frames from film
22 June 2021, 18:06
![](/profiles/img/93607-729-s.jpg)
Might want to use a ruler with tape under it and lay the tracks out that way to get the links straight before you glue. Looking very nice!
26 June 2021, 19:00
![](/profiles/img/88855-657-s.jpg)
Hi, Mark K - thank you
Hi Hekimpd - agree, "taped" ruler should work. Need to find couple 50 cm (19') rulers 🙂. Hope less length will also work 'cause clue will do his work, melt links and stop that curving tendency.
26 June 2021, 19:23
![](/profiles/img/46909-363-s.jpg)
I had some Voyager aftermarket plastic track links end up curving on me as well. I wonder why that happens?
12 August 2021, 20:55
![](/profiles/img/88855-657-s.jpg)
Michael, I'm pretty sure this is imperfectness in casting technology. Guess: temperature, pressure, plastic viscosity, cool mode, seams and voila we have got curving track. Note: the curve/band direction is not changed from link to link - so this is cumulative effect 😎
13 August 2021, 07:48
![](/profiles/img/46909-363-s.jpg)
Right. You couldn't mix and match to even them out; it would just curve in one direction. I'm going to use them in a diorama as a thrown track; I'll keep the kit Magic Tracks in the spares bin.
23 September 2021, 13:17