база даних масштабного моделювання | менеджер запасів
Kon_Bar
Konrad (Kon_Bar)
PL

MiG-21MF-75

Album image #1
Cockpit 
 

Album image #2
Cockpit 
 

Album image #3
Cockpit 
 

Album image #4
Cockpit 
 

Album image #5
Cockpit 
 

Album image #6
Maybe not a Quickboost nozzles, but... 😉 
 

Album image #7
Cowl walls a little sanded 
 

Album image #8
Engine elements painted. 
 

Album image #9
Fuselage ready to assembly. 
 

Album image #10
Narrow ring inside exhaust casing and sharp end of cone added. 
 

Album image #11
0,2 mm gap cancelled by adding PCV plate at the end of wing part (end not front !) 
 

Album image #12
Everything fits great now! 
 

Album image #13
First layer of paint. 
 

Album image #14
Wash 
 

Album image #15
Imitation of tanks (oxygen and ???) added 
 

Album image #16
Tanks are visible 🙂 
 

Album image #17
Very little gap between parts appeared - see small, thin (0,1mm) white line. On both sides so I think it's a project's problem. Filled with Tamiya PLA Paper 🙂 
 

Album image #18
Some other parts (flaps, stabilizers) 
 

Album image #19
And even smaller parts with drilled holes 
 

Album image #20
Small gap appeared again - this time I think it's my mistake :/ 
 

Album image #21
I forgot drill holes in wings before gluing halves - now it was a bit harder to drill them and do not make holes through  
 

Album image #22
Fuel tank bar & canon (broken during drill holes)  
 

Album image #23
Repaired cannon 
 

Album image #24
Fuel tank 
 

Album image #25
Catapult seat 
 

Album image #26
Pylons 
 

Album image #27
Base 
 

Album image #28
Fuel tank painted 🙂 
 

Album image #29
preshading 
 

Album image #30
first layer of target colour 
 

Album image #31
second layer + colors on antennas 
 

Album image #32
bottom side 
 

Album image #33
exhaust 
 

Album image #34
Ch-23 from ResKit - base for (C)h-66, which were used in Poland. 
 

Album image #35
Just to see how H-66 fits to MiG 🙂 
 

Album image #36
I'm not sure should I use panel liner to highlight all rivet lines etc. It can be to "cartoon" with this livery (and preshading). Any advice? 
 

Album image #37
armament frame deciphered v.002 (1/2) 😉 
 

Album image #38
armament frame deciphered (2/2) 
 

Album image #39
H-66 on APU-68 
 

Album image #40
After a little research, it turned out that the MiG-21MF-75 in gray livery could not carry H-66 missiles. MF-75s were used only in the National Air Defense Forces. So I changed the concept again and made RS-2US and R-3S missiles 
 

Album image #41
Find, cut, soak, stick, soften, remove film, mark on diagram and so on for days.... Stencils... 
 

Album image #42
Find, cut, soak, stick, soften, remove film, mark on diagram and so on for days.... Stencils... 
 

Album image #43
Self made decals with chosen number 
 

Album image #44
Decals applied  
 

Album image #45
Close-up on number 
 

Album image #46
Close-up on Polish Air Force signs 
 

Album image #47
Undercarriage covers painted 
 

Album image #48
Undercarriage covers washed 
 

Album image #49
Very subtle wash applied 
 

Album image #50
Current status - I don't have the strength for the front wheel today 😉  
 

Album image #51
Slow but progress 😉 Front wheel & rockets installed. The end is close (I hope). 
 

Album image #52
Just second side 🙂 
 

Album image #53
Almost finished and then... 
 

Album image #54
... I broke decals with seals 🙁 I've to project and print a new ones 
 

Album image #55
Gallery 
 

Album image #56
Gallery 
 

Album image #57
Gallery 
 

Album image #58
Gallery 
 

Album image #59
Gallery 
 

Album image #60
Gallery 
 

Album image #61
Gallery 
 

Album image #62
Gallery 
 

Album image #63
Gallery 
 

Album image #64
Gallery 
 

Коментарі

17 October 2024, 11:32 -

Album info

MiG-21MF-75 - one of 20 MiG-21MFs delivered to Poland, produced at the Gorky factory. It was painted an unusual "dove" gray - as it turned out later with radar-absorbing paint. Armament as for a pair of duty aircraft.

64 зображення
1:72
Завершені
1:72 MiG-21MF Interceptor (Eduard 70141)

Усі альбоми

Переглянути всі альбоми »