Junkers D.1, Roden 1:48
评论
5 7 July, 08:59
Roland Sachsenhofer
With these pictures I open the book report on Roden's Junkers D.1: I tried to extend the interior with some steel wire, the seat belts are from Eduard. For the detailing I downloaded the very interesting building instructions from Wingnut Wings for the large D.1 in 1:32, which is quite helpful if you want to have a good documentation as a basis for detailing. I'm also going to realise one of the WW variants, which I immediately liked: all in Dural/ NMF with only a minimal set of markings.
With these pictures I open the book report on Roden's Junkers D.1: I tried to extend the interior with some steel wire, the seat belts are from Eduard. For the detailing I downloaded the very interesting building instructions from Wingnut Wings for the large D.1 in 1:32, which is quite helpful if you want to have a good documentation as a basis for detailing. I'm also going to realise one of the WW variants, which I immediately liked: all in Dural/ NMF with only a minimal set of markings.
7 July, 09:03
bughunter
Watching!
I have done the short fuselage already, I hope one day I can do the long one too.
Is the engine painting finished? I can recommend the WNW manual for this, still available on WNW page.
Watching!
I have done the short fuselage already, I hope one day I can do the long one too.
Is the engine painting finished? I can recommend the WNW manual for this, still available on WNW page.
8 July, 20:44