时间线

Ben M
So you roast it at 90c for 1.5 hours?

Ingmar Stöhr
Well, now that I think about it, it was more 80°C, but yes, for about 1,5h and then I left it in there till it cooled down to room temperature. The picture shows the cold oven. The red needle belongs to the red scale and the black needle to the black scale. So the temperature in the pic is not 90°C but below 30°C! This picture is some weeks old and I also was briefly mislead... I would not try this method with injection moldet parts! Resin does not melt in the same way as styrene does. It just gets a bit softer at these temperatures.

Gary Victory
Really nice build with some fantastic detail. Thank you for sharing.

Sergey Kalinov
Great work! Congratulations!

Sven Schönyan
It seems I forgot to place a comment here: very well done!

FOG
amazing!