Puma WIP
![Album image #1 Album image #1](/albums/img/2/1/0/437210-25950-13-720.jpg)
![Album image #2 Album image #2](/albums/img/2/1/1/437211-25950-96-720.jpg)
![Album image #3 Album image #3](/albums/img/2/1/2/437212-25950-77-720.jpg)
![Album image #4 Album image #4](/albums/img/2/1/3/437213-25950-53-720.jpg)
![Album image #5 Album image #5](/albums/img/2/1/4/437214-25950-87-720.jpg)
![Album image #6 Album image #6](/albums/img/2/1/5/437215-25950-85-720.jpg)
![Album image #7 Album image #7](/albums/img/2/1/6/437216-25950-93-720.jpg)
![Album image #8 Album image #8](/albums/img/2/1/7/437217-25950-21-720.jpg)
![Album image #9 Album image #9](/albums/img/2/1/8/437218-25950-44-720.jpg)
![Album image #10 Album image #10](/albums/img/2/1/9/437219-25950-29-720.jpg)
![Album image #11 Album image #11](/albums/img/2/2/0/437220-25950-27-720.jpg)
![Album image #12 Album image #12](/albums/img/2/2/1/437221-25950-36-720.jpg)
![Album image #13 Album image #13](/albums/img/2/2/2/437222-25950-64-720.jpg)
![Album image #14 Album image #14](/albums/img/2/2/3/437223-25950-53-720.jpg)
![Album image #15 Album image #15](/albums/img/2/2/4/437224-25950-55-720.jpg)
![Album image #16 Album image #16](/albums/img/2/2/5/437225-25950-71-720.jpg)
![Album image #17 Album image #17](/albums/img/2/2/6/437226-25950-52-720.jpg)
![Album image #18 Album image #18](/albums/img/1/5/7/464157-25950-26-720.jpg)
评论
2 10 February 2018, 20:50
![](/profiles/img/25950-789-s.jpg)
Thanks! It's packed up for a cross country move but I hope to get a light box once we arrive!
15 April 2018, 23:41
![](/profiles/img/25950-789-s.jpg)
Thanks again for the comments Jonathan! If I recall, I turned it down a little lower than usual, maybe 10-12psi instead of 13-15psi that I normally spray, and then got in very close with the airbrush. The paint was Vallejo's Model Air with a 10% thinner and a drop or two or flow improver. It is a little thicker than the "skim milk" consistency people talk of. So I did have to clean the tip with a paper towel soaked in cleaner fairly often. Also worth mentioning that I used a double action airbrush so the psi may have even been a little lower coming out of the airbrush and I only pulled the needle back as far as I had to. I keep a scrap card or post it note handy and always start and stop spraying on the card/off the model to ensure the brush is acting as I intend it to. Hope that helps!!
2 June 2020, 20:06
![](/profiles/img/25950-789-s.jpg)
Thanks Dave! And I'm sure you can do it Jonathan- that's actually the same airbrush that I used.
3 June 2020, 11:37