01 - Assembling the King Tiger
1
March 28, 20202
March 28, 2020Eduard PE Zimerit from Hell!3
March 28, 2020original cables of the kit4
March 28, 2020replaced by steel cables for fishing5
March 28, 20206
March 28, 2020I was planning on making the full interior of the engine compartment and let him open7
March 28, 2020I had already made the radiators in scratch with the remainder of the Pz.IV engine compartment fans that I did not use8
March 28, 20209
March 28, 2020beginning the installation of Eduard's Zimmerit in PE, this kit returned to the box for a few months because of this Zimmerit, gave a great dismay until I had the courage to resume the project!10
March 28, 202011
March 28, 2020the burrs that were left over a lot on the sides, the process was basically aligning each panel, gluing it in place, let the Araldite dry well for 24 hours, then file until it minimizes without damaging the side panel and slightly bend over the subsequent12
March 28, 2020details of the rear hatch, which in the end ended up being glued due to the total absence of details inside the tower!13
March 28, 2020Zimmerit almost finished!14
March 28, 2020how the glue was made so as not to lose alignment!15
March 28, 2020I didn't like the finish of this front MG zimmerit, but even with the countless attempts I tried at the time, I found the least worst of the finishes I could do at that time!16
March 28, 2020zimmerit finished! mantlet is not glued, just dry-fit17
March 28, 2020covering the gaps with milliputty and finishing was terrible in my opinion, but it was the best I had managed to do!18
March 28, 2020making the effect of fall in the cables19
March 28, 2020starting the installation of tools and accessories on the sides of the vehicle20
March 28, 202021
March 28, 2020small dry-fit to see how things are going! and ready for the paint process in the next album22
March 28, 202023
March 28, 202024
March 28, 2020commander's first visit to his future vehicle, following the construction!25
March 28, 2020I forgot to assemble the LBL before applying the primer, so a little post primer return in the kit!26
March 28, 2020Lets build this LBL tracks! it's time to stop forcing those crap DS Tracks down our throats!27
March 28, 2020tracks done.... now back to the paint album! hehehe28
March 28, 2020extra wheels and tracks ready for the primer!29
March 28, 2020the only photo I found of the entire tower Track Link assembly process! ahahahahaha
评论
28 March 2020, 21:26
Project info
73 图片