D.C. 1952 UFO Incident F-94 Starfire
![Album image #1 Album image #1](/albums/img/7/8/9/1033789-46988-57-720.jpg)
Very basic kit, basic build...fuselage closed, filling overdone panel lines - intake seams require almost virtual elimination, as real jet is quite smooth, and seams are almost invisible - plenty of real photos out there, and after seeing the real thing at the National Museum of The USAF in Dayton Ohio, the kit's panel lines are far too pronounced
nationalmuseum.af.mil/
nationalmuseum.af.mil/
![Album image #2 Album image #2](/albums/img/7/9/0/1033790-46988-99-pristine.jpg)
Kit's intakes and splitter plates are very, very, thick and need a lot of thinning - I should have done more before installing them! Now it's tough to do
![Album image #3 Album image #3](/albums/img/7/9/1/1033791-46988-55-720.jpg)
Closing gear doors - pretty good fit, filled voids with small balls of putty to aid keeping doors flush. Filling small gaps, rescribing.
![Album image #4 Album image #4](/albums/img/7/9/2/1033792-46988-52-720.jpg)
Again not a bad fit on the fuselage speed brakes, little bit of putty inside, fill and rescribe.
![Album image #5 Album image #5](/albums/img/7/9/4/1033794-46988-81-pristine.jpg)
While test fitting the lower wing, I noticed it tended the sit below the fuselage belly line, making a fairly tough "step" to eliminate later - so bamboo skewers to the rescue! I've cut them to serve two functions - they both push just very slightly on the fuselage where the wing tops will join the fuselage, reinforcing that seam, and also buts up against the cockpit floor, pushing down with just enough pressure to eliminate the step in the wing/fuselage fit.
![Album image #6 Album image #6](/albums/img/7/9/3/1033793-46988-27-720.jpg)
No step! Time for the epoxy on this particular join.
![Album image #7 Album image #7](/albums/img/4/8/9/1573489-46988-67-720.jpg)
![Album image #8 Album image #8](/albums/img/4/9/0/1573490-46988-15-720.jpg)
PJ pilots, the poor fella up front lost his feet due to fit issues...almost done and ready to drop in-to the cockpit.
![Album image #9 Album image #9](/albums/img/9/6/7/1594967-46988-44-720.jpg)
![Album image #10 Album image #10](/albums/img/1/1/9/1598119-46988-42-720.jpg)
Repainted and in place crew - PJ Productions 50's US pilots.
![Album image #11 Album image #11](/albums/img/1/2/0/1598120-46988-99-720.jpg)
Aerograph scale fit is darn near spot on, and helps rocket pod positioning as no clear reference point given in or on kit parts or instructions.
![Album image #12 Album image #12](/albums/img/1/2/1/1598121-46988-36-720.jpg)
Falcon canopy was SO much better than the kit block of 'clear' kinda sorta canopy with MASSIVE framing
![Album image #13 Album image #13](/albums/img/1/2/2/1598122-46988-87-720.jpg)
Falcon canopy getting interior decal strip framing and FB paint
![Album image #14 Album image #14](/albums/img/1/5/3/1633153-46988-10-720.jpg)
Touching up Canopy /fuselage seam
![Album image #15 Album image #15](/albums/img/1/5/4/1633154-46988-55-720.jpg)
![Album image #16 Album image #16](/albums/img/1/5/5/1633155-46988-65-720.jpg)
New Anti glare panel with Mission Models OD
![Album image #17 Album image #17](/albums/img/1/5/6/1633156-46988-85-720.jpg)
First saucer getting stripped - lights didn't show up very well, so backtracking....
![Album image #18 Album image #18](/albums/img/4/7/1/1635471-46988-63-720.jpg)
Pleasant surprise, very old Microscale decals are working great -
![Album image #19 Album image #19](/albums/img/4/7/2/1635472-46988-90-720.jpg)
![Album image #20 Album image #20](/albums/img/4/7/3/1635473-46988-93-720.jpg)
USAF is from Emhar sheet, test rune cause it looks like it will silver terribly -
![Album image #21 Album image #21](/albums/img/4/7/5/1635475-46988-84-720.jpg)
Different saucer model, testing lights - this may just work - LEDS are from Evan Designs
![Album image #22 Album image #22](/albums/img/0/3/6/1650036-46988-94-720.jpg)
Bare metal foil started
![Album image #23 Album image #23](/albums/img/0/3/7/1650037-46988-46-720.jpg)
foil and reflective cardstock coming along
![Album image #24 Album image #24](/albums/img/0/3/8/1650038-46988-42-720.jpg)
LEDS glued in (Use white glue!)
![Album image #25 Album image #25](/albums/img/0/3/9/1650039-46988-78-720.jpg)
![Album image #26 Album image #26](/albums/img/0/4/0/1650040-46988-40-720.jpg)
references galore, finally found ONE documented serial number at the right time, with this particular squadron, but no photos of this squadron found anywhere - so she will get the standard 50's USAF look, added the blue fin cap just for a bit of color.
![Album image #27 Album image #27](/albums/img/0/4/1/1650041-46988-74-720.jpg)
Nearly done , nav lights to add on tip tanks and wing panels, paint added-on intake on top of nose behind radome (Emhar kit leaves this off)
评论
27 17 July 2021, 01:27
![](/profiles/img/46988-801-s.jpg)
LOTS of sanding... rescribing was a chore but enjoyed it - it's nearing completion -
22 November 2023, 01:31
Album info
Emhar F-94C, Atlantis "Earth vs The Flying Saucers"