时间线
Wall
Steven Van Dyck
添加了一个新相册
添加了一个新相册
2 19 October, 20:12
Steven Van Dyck
Pictures today include the visiting club stands and the contest from the first rows at the entrance until the military vehicles. Figures and planes will come tomorrow.
Pictures today include the visiting club stands and the contest from the first rows at the entrance until the military vehicles. Figures and planes will come tomorrow.
19 October, 20:16
Steven Van Dyck
拥有此物
拥有此物
Olifant road wheels (correct dim/shape) Hobby Boss
Quickwheel 1:35
QW-X058 19 October, 18:05
October 18, 2024
Steven Van Dyck
添加了一个新相册
添加了一个新相册
All comments (17) » 23 8 April, 00:28
Steven Van Dyck
The half-relief ducts in the wheelbays are replaced with scratch pipes that are now correctly shaped. It seems Special Hobby had reversed the reference picture and bent the tubes the wrong way around. I found a 2 mm steel wire that was barely bendable into the required shape, and a 1,5 mm aluminium wire that bent far easier for a side duct. In the process I managed to lose one of the landing gear parts.
The half-relief ducts in the wheelbays are replaced with scratch pipes that are now correctly shaped. It seems Special Hobby had reversed the reference picture and bent the tubes the wrong way around. I found a 2 mm steel wire that was barely bendable into the required shape, and a 1,5 mm aluminium wire that bent far easier for a side duct. In the process I managed to lose one of the landing gear parts.
18 October, 12:25
October 17, 2024
October 14, 2024
Steven Van Dyck
添加了一个新相册
添加了一个新相册
3 5 October, 10:18
Steven Van Dyck
Thanks. The frame is now assembled after removing of sinkmarks on both beams. These were not present on the four wheel truck frame that is still included. The first set of three SKP lights is added to the rear.
Thanks. The frame is now assembled after removing of sinkmarks on both beams. These were not present on the four wheel truck frame that is still included. The first set of three SKP lights is added to the rear.
14 October, 13:30
October 5, 2024
October 4, 2024
Steven Van Dyck
将此物品标记为
将此物品标记为
"Phasor 90" Paired-cone Antennas (set of 12) for Vietnam War-era ships.
Model Monkey 1:400
400-Phasor 90 2018 新模具 4 October, 15:25
Steven Van Dyck
将此物品标记为
将此物品标记为
US Navy Floater Net Baskets Can be used as inserts for photo-etch baskets or by themselves.
Model Monkey 1:350
350-FloaterBaskts 多主题 (11)4 October, 15:24
Steven Van Dyck
将此物品标记为
将此物品标记为
US Navy Floater Net Baskets Can be used as inserts for photo-etch baskets or by themselves.
Model Monkey 1:350
350-FloaterBaskts 多主题 (11)4 October, 15:23
Steven Van Dyck
将此物品标记为
将此物品标记为
US Navy Floater Net Baskets Can be used as inserts for photo-etch baskets or by themselves.
Model Monkey 1:350
350-FloaterBaskts 多主题 (11)4 October, 15:23
Steven Van Dyck
将此物品标记为
将此物品标记为
US Navy Floater Net Baskets Can be used as inserts for photo-etch baskets or by themselves.
Model Monkey 1:350
350-FloaterBaskts 多主题 (11)4 October, 15:22
October 3, 2024
Steven Van Dyck
拥有此物
拥有此物
SA-13 GOPHER 9K 35 STRELA 10 / MT-LB / BMP23 / HOSTA / 2 S 1 GVODZIKA late type tracks.
Friulmodel 1:35
ATL-188 2020 新模具 3 October, 09:50
Steven Van Dyck
拥有此物
拥有此物
Fouga CM.170 Magister - wheels set (weighted)
ResKit 1:48
RS48-0308 3 October, 09:49
September 30, 2024
September 25, 2024
Steven Van Dyck
将此物品标记为
将此物品标记为
SA-13 GOPHER 9K 35 STRELA 10 / MT-LB / BMP23 / HOSTA / 2 S 1 GVODZIKA late type tracks.
Friulmodel 1:35
ATL-188 2020 新模具 25 September, 11:55
Steven Van Dyck
将此物品标记为
将此物品标记为
Fouga CM.170 Magister - wheels set (weighted)
ResKit 1:48
RS48-0308 25 September, 11:53
September 22, 2024
Steven Van Dyck
添加了一个新相册
添加了一个新相册
All comments (11) » 14 29 June, 00:14
Steven Van Dyck
All welcome, the gun is now being built with the Aber barrel in it. There seem to be some dimension differences that can cause trouble for the fit of the gun cradle. One image of the floor shows some surprising choices of the Eduard set. It doesn't provide enough covers for all compartiments, and it doesn't reproduce the non-skid pattern correctly like Dragon did. It has only half of the coverage. I'd like to omit or replace these PE-parts for this reason. Maybe I'll use the diamond plate shown in some museum pieces, or look for a finer generic plate.
All welcome, the gun is now being built with the Aber barrel in it. There seem to be some dimension differences that can cause trouble for the fit of the gun cradle. One image of the floor shows some surprising choices of the Eduard set. It doesn't provide enough covers for all compartiments, and it doesn't reproduce the non-skid pattern correctly like Dragon did. It has only half of the coverage. I'd like to omit or replace these PE-parts for this reason. Maybe I'll use the diamond plate shown in some museum pieces, or look for a finer generic plate.
3 September, 00:53
Steven Van Dyck
I found some strange errors in the manual connected to the gun elevating parts. Left and right parts seem to be switched on the drawing and one of the arms is not mirrored. First I filed the round pins square to fit both arms, but there's even a slot on the axle that necessitated the removal and turning around of parts B26 and B27. Only then I got a working cradle elevation according to reference photos. None of this was to be found in any review of the Dragon Pak 40, probably because these reviews are of unbuilt kits. The Voyager brass splintershields are like the AFV kit, only they are not pre-bent (as in my AFV kit one was wrongly bent).
I found some strange errors in the manual connected to the gun elevating parts. Left and right parts seem to be switched on the drawing and one of the arms is not mirrored. First I filed the round pins square to fit both arms, but there's even a slot on the axle that necessitated the removal and turning around of parts B26 and B27. Only then I got a working cradle elevation according to reference photos. None of this was to be found in any review of the Dragon Pak 40, probably because these reviews are of unbuilt kits. The Voyager brass splintershields are like the AFV kit, only they are not pre-bent (as in my AFV kit one was wrongly bent).
22 September, 00:49
September 20, 2024
September 19, 2024
September 16, 2024
Steven Van Dyck
添加了一个新相册
添加了一个新相册
6 15 September, 19:12
Steven Van Dyck
At this event I participated to the contest with 4 models. 3 of them won bronze and USS Columbia in ABSD1 won Best of Show. At the lottery I also won a great AMK Fouga Magister and I collected some orders at Domino.
At this event I participated to the contest with 4 models. 3 of them won bronze and USS Columbia in ABSD1 won Best of Show. At the lottery I also won a great AMK Fouga Magister and I collected some orders at Domino.
15 September, 19:15
Alexander Grivonev
Congratulations mate! Was curious about that Fouga Magister, looks like some metal frame parts?
Congratulations mate! Was curious about that Fouga Magister, looks like some metal frame parts?
15 September, 21:06
Steven Van Dyck
Thanks, Alexander, best check this review to see the contents. hyperscale.com/2017/..k88004reviewjm_1.htm
It has also an optional clearpart fuselage.
Thanks, Alexander, best check this review to see the contents. hyperscale.com/2017/..k88004reviewjm_1.htm
It has also an optional clearpart fuselage.
15 September, 22:49
Lost_Erik
Thanks for posting all of these! Good show.
Congratulations on best in show and the bronze recognition! 👍
Thanks for posting all of these! Good show.
Congratulations on best in show and the bronze recognition! 👍
16 September, 00:07
September 14, 2024
Steven Van Dyck
拥有此物
拥有此物
Canopy & Wheels Paint Masks for F-14A/D Tomcat 1/48 for Tamiya kits
DN Models 1:48
48/827-102 2021 新模具 14 September, 19:11
September 10, 2024
September 6, 2024
September 5, 2024
September 3, 2024
August 30, 2024
August 29, 2024
August 21, 2024
August 17, 2024
August 10, 2024
August 8, 2024
August 7, 2024
August 6, 2024
August 5, 2024
August 1, 2024
Steven Van Dyck
拥有此物
拥有此物
M3 Half-track Sagged front wheel set (1) For AFV, Dragon M2/M3/M16
Def.Model 1:35
DW30050 2020 新模具 多主题 (1!!)1 August, 01:15
July 31, 2024
July 25, 2024
Steven Van Dyck
将此物品标记为
将此物品标记为
M3 Half-track Sagged front wheel set (1) For AFV, Dragon M2/M3/M16
Def.Model 1:35
DW30050 2020 新模具 多主题 (1!!)25 July, 21:14
Steven Van Dyck
拥有此物
拥有此物
Road Wheels for FlaK/Nebelwerfer Trailers (Commercial Pattern A)
Panzer Art 1:35
RE35-208 25 July, 09:07
July 22, 2024
Steven Van Dyck
拥有此物
拥有此物
WWII USN
USS Massachusetts BB-59 1945 - Complete Upgrade Set for Trumpeter 05306 Five Star Model 1:350
FS350048 2017 22 July, 11:36
July 20, 2024
wnolder.php?lang=zh
2024-07-20 14:59:56
2014-05-15 21:19:56
15656
/ajax/wnolder.php?lang=zh&sd=2024-07-20 14:59:56&md=2014-05-15 21:19:56&filter=&w=15656
todo