Brückenlegepanzer Biber
Tanks
- Subject:
- 比例:
- 1:72
- 状态:
- 已完成
- 已开始的:
- January 14, 2015
- 已完成:
- October 10, 2015
- 用时:
- Too long
This will be going onto a Elefant SLT 50-3 eventually, tracks and running gear now done and onto painting the upper hull extension arm etc
Hull and extension arm constructed just some detailing to do before the rear arm and bridge goes on.
To be fair there is not much tank to see after the bridge goes on in the travel mode.
Now for the Elefant SLT 50-3 to carry it.
Not a lot of the tank hull can actually be seen other than the running gear once the bridge is mounted.
项目库存
完整套件
/zh/search.php?q=*&fkMATEID[]=17334&showast=no&fkWORKBENCH[]=WB17334&page=projects&project=11467?
相册
评论
17 January 2015, 13:39
Campbell BrandPicked this up at a model show fir £5 100% complete only the road wheels had been started. This monkey will be going on the back of an Elefant SLT 50-3 tank transporter eventually. I really like the 3 colour scheme and if the Revell Panzerhaubitze 2000 was anything to go by this will be an enjoyable build. If anyone has any tips I would appreciate any input.
17 January 2015, 13:44
Campbell BrandHit a bit of a problem, bought this for £5 as it had been minor ly started but 100% complete. Unfortunately the lower hull sides had been attached to the lower hull which will make putting on the link and length tracks very awkward, wheels on drive sprocket on, top rollers on, can slide the top length on no probs but attaching the individual links round behind the drive sprocket is challenging. Any helpful suggestions welcome. PS there is no side skirts to hide the running gear.
12 March 2015, 20:17