hexagonal bolt heads various sizes
Alliance Model Works | Nr. LW35025
Fakty
- Marka/Wydawnictwo:
- Alliance Model Works
- Tytuł:
- hexagonal bolt heads various sizes
- Numer:
- LW35025
- Skala:
- No
- Rodzaj:
- Zestaw waloryzacji
- Temat:
- Bolts and Nuts » Kawałki i kawałki (Akcesoria)
Giełda
Sklepy internetowe
€ 10.00
USD 11.54Na stanie »Alternatywne jednostki SKU dla Alliance Model Works LW35025:
Uwaga: Ceny i dostępność są tylko wskazówkami. Sprawdź dokładnie, czy produkt rzeczywiście pasuje!
Recenzja zawartości
Recenzje zewnętrzne
Nie wiemy nic o recenzjach na ten temat hexagonal bolt heads various sizes (#LW35025) z Alliance Model Works.
Projekty
82 zdjęć/zdjęcia
Trumpeter's Challenger 2 MBT, scale (00345)1:35
Testing outdoor photography. Brr, too cold. :| I have learned that my camera adds increasing blurring towards the edges,...
Komentarzy
Treehugger
A fun thing about this particular product, is that these photo etch bolt heads do not require any detachment, as the bits of photo etch are stuck to an adhesive plate. So one can just grab a bolt head with a small tweezer and apply it immediately . 🙂 The bits of photo etch has to be glued on though, they do not contain any adhesive from what I can tell.
I should point out that the thickness of this photo etch is limited to, well, I am not sure, looks like fairly standard thickness to the photo etch plate, which may or not be adequate. I wish the photo etch thickness was a little thicker. I guess one could stack two bits on top of each other, but that seems like it might be extremely difficult to achieve.
Also included, some kind of Y shaped thingies, and what looks like the tip of the bolt shaft itself, presumably to be glued on top of the bits of flat bolt head. These small round tips are limited in number, compared to the flat bolt heads.
A fun thing about this particular product, is that these photo etch bolt heads do not require any detachment, as the bits of photo etch are stuck to an adhesive plate. So one can just grab a bolt head with a small tweezer and apply it immediately . 🙂 The bits of photo etch has to be glued on though, they do not contain any adhesive from what I can tell.
I should point out that the thickness of this photo etch is limited to, well, I am not sure, looks like fairly standard thickness to the photo etch plate, which may or not be adequate. I wish the photo etch thickness was a little thicker. I guess one could stack two bits on top of each other, but that seems like it might be extremely difficult to achieve.
Also included, some kind of Y shaped thingies, and what looks like the tip of the bolt shaft itself, presumably to be glued on top of the bits of flat bolt head. These small round tips are limited in number, compared to the flat bolt heads.
28 December 2018, 16:10