Newsfeed-

Yifei Li
Magnificent Work!! Where can you get those decals by the way?

Evgeny Brovkin
Thank, mate.
But, It's not a decal! It's paint masks.
I'v bought it at local market. Here:
arma-models.ru/catal..yazha_okhotnik_1_72/
I'v also bought in this shop resin exhaust and cockpit with seat🙂

Łukasz Gliński
Brilliant! The group pics are cool too 👍

Skyhiker
Beautiful birds.

Neuling
Very impressive!

Evgeny Brovkin
Thank's mates. Will add some complex photos of all nine planes🙂

Cristian A
super nice build!

Oliver
Cool Bird!

Doubtingmango
So I just finished this little Italian job. The decals came out with a lot of the edges showing, which then got a lot worse when I added some washes. I used Microset on the decals, and then sealed them with Tamiya semi-gloss before the washes, but it actually looks like the washes got under the decals. Any thoughts?

Bogicevic Vladimir
It looks like you haven't spray gloss coat before you applied decals. Or decals didn't set well. There are two solutions. One is lacquer thinner. Put the thinner with fine brush in dots over the place where you have silvering. Thinner should destroy the film. If it raises paint under, just leave it, it will settle back. Important thing here is that, once you applied thinner, you shouldn't touch decal for something like 20 minutes, at least. Second way is mix of sugar and water, half - half. You make a hole with a needle on the decal, than you put mix on the top. It should enter in the space between decal and paint and, when drayed, make a gloss film in between them which will act as a gloss under the decal. Wipe excess mix with wet cloath and you are done.

Mr James
How annoying. I've never heard of the sugar water trick from Bogicevic. I'll be interested if this works. If the thinner, sugar trick fails, what else can you do but use a scalpel to cut around them, since you've sealed it,

Mr James
Oh, nice paintjob by the way

Doubtingmango
Thanks mates! I believe Bogicevic is right. I think I did fail to gloss coat before the decals. I think I'll try the sugar water first

Bogicevic Vladimir
Ok. There are few small tings I should add then. Heat the water first, when hot it will disolve sugar beter and apply it while it's still warm, it will have more viscosity. Make small hole or slice with modeling knife, put few drops of mix on the top and let it dry. You will see emidiatly if it's penatrating. When dry, wipe carefully excess mix with moist cloth. Repeat where neaded. I know it sounds ridiculous, but it worked for me many times.

Dominik Weitzer
"At the end of the day" it looks really nice and clean! well done!

István Szücs
Great work so far, I love the yellow Mustangs (and so many other cars...). Which AK gloss varnish did you use?