The Lindberg Line: Dornier Do 17 Z_Srikanth

Bruce Huxtable
Have fun on your new model, but make sure to remove any primer from surfaces that will have glue applied. Looking forward to following this project 👍

Srikanth Kadambi
yes will be sanding them
I have 600, 1000 and 2000 gsm sand papers
Do you suggest/recommend anything else?

Bruce Huxtable
I usually gently scrape the surfaces with a scalpel blade, as it can get into small places. Also very good for removing any thin lines from the mould joint line, but used with a little more pressure. Very fine wet-and-dry paper is indeed very useful too. As always, have a little practice on a piece of sprue, holding the blade almost perpendicular to the surface.

Srikanth Kadambi
thanks for this tip Bruce. Will follow this advice