Стіна
Wall
Kenneth
додав новий фотоальбом.
додав новий фотоальбом.
12 зображення
Danish Spitfire XIНовий: 18 November, 19:41 1:72
This will be my first attempt at reproducing wear/weathering, and have just had a go with an AK Weathering Pencil. Too m...
All comments (25) » 25 15 January, 16:19
March 17, 2024
Kenneth
додав новий фотоальбом.
додав новий фотоальбом.
All comments (5) » 21 16 March, 08:07
Kenneth
Thank you, Robert! Apart from the floats and the small fiddly windows, it went together quite well.
Thank you, Robert! Apart from the floats and the small fiddly windows, it went together quite well.
17 March, 12:18
March 16, 2024
March 10, 2024
Kenneth
Would anybody happen to have any photos of the interior of a Swedish Air Force („Flygvapnet“) Boeing-Vertol Hkp 4? Specifically as used by the air force, not the navy version….
10 March, 10:15
Kenneth
володіє цим предметом
володіє цим предметом
CH-46 Sea Knight - wheels w/ weighted tyres
Armory 1:72
AR AW72364 10 March, 10:10
January 27, 2024
Kenneth
володіє цим предметом
володіє цим предметом
Canopy Mask: Spitfire PR.Mk.XI - KP Kits -
Peewit 1:72
M72300 27 January, 12:59
January 26, 2024
January 25, 2024
Kenneth
володіє цим предметом
володіє цим предметом
25 January, 22:29
Kenneth
I've always wanted this since I took up modeling again a couple, but until a couple of days ago it effectively wasn't available anywhere in Europe. Managed to get one from Super Hobby in Poland, they were sold out a couple of days later. Looks a bit daunting in places, particularly the engine which seems to consist of an inordinate amount of parts. I can't see any differences between this kit and the original Kitty Hawk offering; the decals are the same, for example.
I've always wanted this since I took up modeling again a couple, but until a couple of days ago it effectively wasn't available anywhere in Europe. Managed to get one from Super Hobby in Poland, they were sold out a couple of days later. Looks a bit daunting in places, particularly the engine which seems to consist of an inordinate amount of parts. I can't see any differences between this kit and the original Kitty Hawk offering; the decals are the same, for example.
25 January, 22:33
January 21, 2024
Kenneth
Nice, good-value-for-money re-issue of the ICM kit, with the following minor issues:
1) The rudder control horns are positioned too high up on the rudder, they need to be located one rudder rib distance further down
2) Decals for HB-UBC are provided in the kit, this has a tail wheel (not in the kit) and not a tail skid.
3) The rudder control cables connect to a sliding bracket (not in the kit) extending out of the fuselage, and do not come out of the fuselage.
4) Flying wires are thicker than the control surface cables, not the same thickness as suggested in the instructions.
5) The L-shaped part on the fuselage lower surface is an idler lever for the aileron controls, but the rest of that arrangement is missing.
On a positive note, the blind flying hood is also included in the kit (not used on the two civil aircraft for which decals are provided), as is an upper rear fuselage part without the anti-spin strakes, enabling an (earlier) DH.82 to be built as well, and not only a DH.82A.
Looking forward to getting started with it!
Nice, good-value-for-money re-issue of the ICM kit, with the following minor issues:
1) The rudder control horns are positioned too high up on the rudder, they need to be located one rudder rib distance further down
2) Decals for HB-UBC are provided in the kit, this has a tail wheel (not in the kit) and not a tail skid.
3) The rudder control cables connect to a sliding bracket (not in the kit) extending out of the fuselage, and do not come out of the fuselage.
4) Flying wires are thicker than the control surface cables, not the same thickness as suggested in the instructions.
5) The L-shaped part on the fuselage lower surface is an idler lever for the aileron controls, but the rest of that arrangement is missing.
On a positive note, the blind flying hood is also included in the kit (not used on the two civil aircraft for which decals are provided), as is an upper rear fuselage part without the anti-spin strakes, enabling an (earlier) DH.82 to be built as well, and not only a DH.82A.
Looking forward to getting started with it!
21 January, 10:52
Kenneth
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
21 January, 10:37
January 13, 2024
January 12, 2024
Kenneth
added a new article to його personal gallery:
added a new article to його personal gallery:
7 12 January, 05:19
Roland Sachsenhofer
Wonderful and inspiring model, great outcome- and I really like your article!
Wonderful and inspiring model, great outcome- and I really like your article!
12 January, 06:15
Kenneth
Many thanks, Roland. Very flattering, as I have been enjoying and admiring your models and building style on Modellversium for many, many years!
Grüße aus München
Kenneth
Many thanks, Roland. Very flattering, as I have been enjoying and admiring your models and building style on Modellversium for many, many years!
Grüße aus München
Kenneth
12 January, 06:59
January 11, 2024
January 7, 2024
Kenneth
володіє цим предметом
володіє цим предметом
Supermarine Spitfire PR Mk.XI "International"
Kovozávody Prostějov (KP) 1:72
KPM0293 (72293) 2022 Нові деколі 7 January, 15:24
January 2, 2024
December 28, 2023
December 27, 2023
December 25, 2023
December 24, 2023
wnolder.php?lang=uk
2023-12-24 15:33:15
2023-12-24 15:24:51
136622
/ajax/wnolder.php?lang=uk&sd=2023-12-24 15:33:15&md=2023-12-24 15:24:51&filter=&w=136622
todo