Type AG 1910 London Taxi

Sam101
Decent little kit, a few small issues but nothing too complicated - happy with the results and enjoyed the unusual subject matter.

7884C
I found this kit so frustrating it went in the bin.
In order
Piece A12 the rear of the chassis - the pins and slots do not go together easily
Step 2 The chassis would not lie straight when attached to the mudguards/running boards,
B4 - A warped doorframe that may have been ok once other pieces were built around it,
Step 4 Two 0.9 mil holes to be drilled into the door - why are they not pre drilled
Step 5, the instruction shows the mudguards fitting into the wrong hole on the body
Step 6 A44 and A45, again the slots for fitting are inadequate
Step 10 A22 is so flimsy it broke while smoothing very gently with a file
Steps 15 and 17, the pins and slots didn't match, and the spindle on A32 was too long Despite not trying to fit the engine and driveshaft until all previous cementing was set and dry, trying to fit them in place resulted in other parts breaking off.
Having fitted them as best I could, the radiator did not then fit
At that point I gave up.

I have been model making for 2 years since retiring and this is the first kit that has gone in the bin