News Feed

Marcin Dudek
A new build starte 🙂. It seems quite easy but one thing puzzles me - the tracks. They compose of 4 straight plastic parts and instruction says to bend them with hair dryer. It is first time I encountered this type of tracks. Anyone tried doing something like this?

Snake Plissken
I have heard of this type of assembly but have never built one. However, I have lots of experience heating and softening styrene plastic. You can also try very hot or boiling water -- soak the tracks in boiling water, then fish them out of the water with long tweezers and bend them around the rear sprocket, idler and road wheels and hold until they cool. You may even get by using no heat, just slowly and carefully bend curves into the tracks.

Marcin Dudek
Thanks for help Snake! That tip is very helpfull 🙂

Guy Rump
Following. 👍

Marcin Dudek
You're welcome Guy 🙂

Marcin Dudek
After some work done I need to say I am a little disappointed with this kit. Instruction includes some mistakes and it is not always easy to read how and where exactly a specific part should be located. More over I expected more from new molds (parts require a lot of work to remove additional plastic).

Snake Plissken
Hi Marcin. My advice is to *expect mistakes* and do your research accordingly. It may or may not be fun to research the T-55 but most of the photos or line drawings you can find online are free, it just takes some time.

Marcin Dudek
Sure thing Snake 🙂. References in the Net are more than sufficient.

Snake Plissken
Good job adding the injector lines on the engine. I overlooked it the first time. 👍

Marcin Dudek
Thanks Snake 🙂. I was considering adding some more parts to the engine but they wouldn't be visible after assembly so I left it as it is. Thanks one again for the track bending tips, they were very helpfull.

Marcin Dudek
Some job with wearhering done. Still, I forgot to apply the decals first 🤦

bughunter
Why? Which feature do you miss in a (mobile) web page?
There are app requests marked as "Unlikely" already, e.g. this one:
SCM Newsfeed
FYI there is a prototype of the mentioned bar code scanner, in the web page.
Personally I prefer mobile web pages over installing apps.