hexagonal bolt heads various sizes
Alliance Model Works | No. LW35025
Fapte
- Marca:
- Alliance Model Works
- Titlu:
- hexagonal bolt heads various sizes
- Număr:
- LW35025
- Scară:
- No
- Tip:
- Set detaliat
- Subiect:
- Bolts and Nuts » Biți și piese (Accesorii)
Piata de desfacere
Magazine online
€ 10.00
USD 10.95In stoc »SKU-uri alternative pentru Alliance Model Works LW35025:
Notă: Prețurile și disponibilitatea sunt numai indicații. De asemenea, verificați dacă produsul se potrivește cu adevărat!
In-box recenzii
Recenzii externe
Nu știm despre niciun comentariu în cutie pentru acest lucru hexagonal bolt heads various sizes (#LW35025) din Alliance Model Works.
Comentarii
Treehugger
A fun thing about this particular product, is that these photo etch bolt heads do not require any detachment, as the bits of photo etch are stuck to an adhesive plate. So one can just grab a bolt head with a small tweezer and apply it immediately . 🙂 The bits of photo etch has to be glued on though, they do not contain any adhesive from what I can tell.
I should point out that the thickness of this photo etch is limited to, well, I am not sure, looks like fairly standard thickness to the photo etch plate, which may or not be adequate. I wish the photo etch thickness was a little thicker. I guess one could stack two bits on top of each other, but that seems like it might be extremely difficult to achieve.
Also included, some kind of Y shaped thingies, and what looks like the tip of the bolt shaft itself, presumably to be glued on top of the bits of flat bolt head. These small round tips are limited in number, compared to the flat bolt heads.
A fun thing about this particular product, is that these photo etch bolt heads do not require any detachment, as the bits of photo etch are stuck to an adhesive plate. So one can just grab a bolt head with a small tweezer and apply it immediately . 🙂 The bits of photo etch has to be glued on though, they do not contain any adhesive from what I can tell.
I should point out that the thickness of this photo etch is limited to, well, I am not sure, looks like fairly standard thickness to the photo etch plate, which may or not be adequate. I wish the photo etch thickness was a little thicker. I guess one could stack two bits on top of each other, but that seems like it might be extremely difficult to achieve.
Also included, some kind of Y shaped thingies, and what looks like the tip of the bolt shaft itself, presumably to be glued on top of the bits of flat bolt head. These small round tips are limited in number, compared to the flat bolt heads.
28 December 2018, 16:10
proiecte
82 imagini
Trumpeter's Challenger 2 MBT, scale (00345)1:35
Testing outdoor photography. Brr, too cold. :| I have learned that my camera adds increasing blurring towards the edges,...